LSI LSIiBBU08 Guía de instalación descargar pdf (Pagina 12)

Page 12 LSI Corporation Confidential | August 2010

MegaRAID LSIiBBU08 Intelligent Battery Backup Unit Quick Installation GuideConnecting the LSIiBBU08 Remotely to the MegaRAID SAS RAID Controller

Figure 6: Connecting the Interposer Card to the MegaRAID SAS 9260-8i RAID Controller

Connecting the Cable Between the

Interposer Card and the LSIiBBU08

Follow these steps to connect the cable between the interposer card on the controller

and the LSIiBBU08.

1. Mount the LSIiBBU08 to the chassis of your computer based on the location and the

type of mounting option.

2. With the controller on a flat, clean, static-free surface, ground yourself and make

sure the system is grounded.

3. Remove the cable included in the Remote Battery Kit (sold separately).

4. Insert one end of the cable into the 20-pin J2 connector on the LSIiBBU08 and the

other end into the 20-pin J1 connector on the interposer card, as shown in Figure7.

Align the black triangles on the connectors to make sure they are connected

properly.

NOTE: The cable connectors are polarized and can be inserted into the connectors on

the interposer card and the LSIiBBU08 only if the rails on the cable connectors align with

the slots on the other connectors. Do not force the cable into the 20-pin connectors. The

cable end inserts into the connector with minimal resistance.

85039-07

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sin comentarios

LSI LSIiBBU08 Guía de instalación Pagina 12