LSI 9690SA-8E-KIT Guía de instalación descargar pdf (Pagina 112)

Chapter 2. CLI Syntax Reference

104 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2

/cx/bbu show attribute [attribute ...] where attributes are:

status|temp|tempstat|tempval|volt

/cx/bbu show all

/cx/bbu test [quiet]

Warning: Can take up to 24 hours to complete. Write cache

will be disabled during the test.

/cx/bbu enable

/cx/bbu disable [quiet]

/cx/bbu show

The /cx/bbu show command presents a summary report on the specified BBU

object.

Example:

//localhost> /c0/bbu show

Name OnlineState BBUReady Status Volt Temp Hours LastCapTest

---------------------------------------------------------------------------

bbu ON No Testing OK OK 72 01-Apr-2010

The command output indicates that the battery capacity was last measured on

01-Apr-2010. The battery typically lasts for 72 hours from the last tested date.

In this example, the BBU unit is currently testing the battery. Both voltage

and temperature are normal. The BBU is not ready to backup the write cache

on the controller (due to the testing). (For complete information about the

BBU, see the user guide that came with your 3ware RAID controller).

/cx/bbu show attribute [attribute ...]

The /cx/bbu show attribute command shows the current setting of one or

more of the given attributes on the BBU board. You can specify one or many

attributes. If you specify an invalid attribute, the loop terminates. Possible

attributes are: batinst, bootloader, cap, fw, lasttest, pcb, ready, status, serial,

temp, volt.

/cx/bbu show batinst

The /cx/bbu show batinst command shows the date when the current battery

was installed.

Note: If the BBU is either not present or disabled, the following is shown after the

command: //localhost> /c0/bbu show.

Error: (CLI:053) Battery Backup Unit is not present.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 137 138

Sin comentarios

LSI 9690SA-8E-KIT Guía de instalación Pagina 112