LSI 9690SA-8E-KIT Guía de instalación descargar pdf (Pagina 116)

Chapter 2. CLI Syntax Reference

108 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2

/c1/bbu Battery Temperature Status = OK

/c1/bbu Battery Temperature Value = 25 deg C

/c1/bbu Estimated Backup Capacity = 241 Hours

/c1/bbu Last Capacity Test = 22-Jun-2008

/c1/bbu Battery Installation Date = 20-Jun-2008

/c1/bbu Bootloader Version = BBU 0.02.00.002

/c1/bbu PCB Revision = 65

/cx/bbu test [quiet]

The /cx/bbu test command starts the battery capacity test. The test can take

up to 24 hours to complete. During the test, the BBU is not capable of backup

operation and the write cache of all units attached to that controller is

disabled. After the test is completed successfully and the BBU status returns

to OK, the write cache is re-enabled.

Asynchronous Event Notification (AEN) messages are also generated by

controllers to notify you of the command status.

You can check for AENs with the controller alarms command

/cx show alarms [reverse] or with the commands /cx show events [reverse]

or /cx show AENs [reverse]. Using the reverse attribute lists the most recent

AEN message at the top of the list. (For a list of all AENs, see the user guide

that came with your 3ware RAID controller.)

/cx/bbu enable

The /cx/bbu enable command enables BBU detection on the controller. If the

BBU is Ready, the controller utilizes BBU functionality in the event of a

power failure.

/cx/bbu disable [quiet]

The /cx/bbu disable command disables BBU detection on the controller.

When disabled, the controller ignores the existence of the BBU and shows

that no BBU is installed even if a BBU is physically attached.

Note: Once started, the test can not be terminated before it completes. Write

cache cannot be enabled until the test completes.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 137 138

Sin comentarios

LSI 9690SA-8E-KIT Guía de instalación Pagina 116