LSI 9690SA-8E-KIT Guía de instalación descargar pdf (Pagina 70)

Chapter 2. CLI Syntax Reference

62 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.2

2 Use the /cx del selftest command to remove any of the scheduled tasks

which do not match your desired schedule.

3 Use the /cx add selftest command to create the selftest schedule slots you

want (described above.)

4 Use the /cx set selftest=enable command to enable the schedule (this

enables all selftest schedule slots).

del rebuild=slot_id

The /cx del rebuild command removes the rebuild background task slot

slot_id from the Rebuild Task Schedule.

Example:

//localhost> /c1 del rebuild=2

removes the rebuild background task in slot 2.

del verify=slot_id

The /cx del verify command removes the verify background task slot slot_id

from the Verify Task Schedule.

Example:

//localhost> /c1 del verify=3

removes verify background task in slot 3.

del selftest=slot_id

The /cx del selftest command removes (or unregisters) the selftest

background task slot slot_id from the Self Test Task Schedule.

Example:

//localhost> /c1 del selftest=3

Removes the selftest background task in slot 3.

set dpmstat=on|off

The /cx set dpmstat command allows you to enable or disable the Drive

Performance Monitor (DPM).

By setting dpmstat to on, you can enable the gathering of statistics for drives

when I/O is running. These statistics can be helpful when troubleshooting

performance problems.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 137 138

Sin comentarios

LSI 9690SA-8E-KIT Guía de instalación Pagina 70